This should give you a hint to which file should be uploaded to your controller. Replacement controllers come preinstalled with the following licenses: permanent base and evaluation base, base-ap-count. These licenses are base count licenses that cannot be deleted or transferred. Step 6 Click Save Configuration to save your changes. Operation is dedicated to the Data Port, and in effect using the management interface and any dynamic interfaces defined.
The default value is 20 seconds. Step 9 If the desired license is not being used by the controller, follow the instructions in the or the to change the license that is used by the controller. Pursuant to such terms, Cisco is entitled to confirm that your access point enablement is properly licensed. You may remove supplemental licenses from one controller and transfer to another controller in the same product family. That is, the traffic stream metrics is not collected by default.
Step 7 Click Apply to commit your changes. Step 4 At the Re-enter Password prompt, reenter the new password. A: The smart account creator the customer or the partner, in the case of partner-managed accounts can set who gets notified when the customer goes out of compliance. The denial count sets the maximum number of association denials during load balancing. Traffic Type 0 Best effort 1 Background 2 Spare 3 Excellent effort 4 Controlled load 5 Video, less than 100-ms latency and jitter 6 Voice, less than 10-ms latency and jitter 7 Network control You can configure each priority level independently, or you can use the all parameter to configure all of the priority levels at once.
The controller validates and stores your entries in the database. No other permanent licenses are installed. After your request is approved, you can install the old license on the replacement controller. I am going to backup the license files, save the current configuration you will have to reboot the controller and you don't want to lose any changes and also backup the configuration. Step 2 Select Serial Port, and click Next.
The configuration and trustpoint will be pushed to the device and the user will be logged out. The default value is disabled. When this occurs, the access point forwards the request to the controller. Step 6 Enter the config snmp trapreceiver create name ip-address command to configure a destination for a trap. Step 3 When the process is completed successfully, user will be prompted to Reboot to take into effect of the new software image.
The access point also collects the measurements every 5 seconds, prepares 90-second reports, and then sends the reports to the controller. The ap-count licenses and their corresponding image-based licenses are installed together. This process aids in the seamless transfer of multicast data to the client. When a message appears indicating that the registration is complete, click Download License. A value of 0 imposes no bandwidth restriction on the profile. If no valid licenses are installed, the controller can always operate in base level.
This information is included in your purchase records. Step 9 On the Review and Submit page, verify that all information is correct and click Submit. Per-radio limits The practical per-radio limit is about 200 associations. There are couple of questions regarding licensing: 1. Step 2 Select the 11n Mode check box to enable 802. Intra-Controller Roaming Each controller supports same-controller client roaming across access points managed by the same controller. The default value for both check boxes is disabled.
Is there any way to generate a new license when the serial number changes? Step 13 Click Next until completing the steps to add the vswitch. Note This is similar to installation using Fedora. You can add additional access point capacity through capacity adder licenses available at 25, 50, 100 and 250 access point capacities. It also shows the maximum number of access points allowed by the license on the controller, the number of access points currently joined to the controller, and the number of access points that can still join the controller. To disable the band, unselect the check box.